Installing a new water heater in your home is one thing that most do-it-yourselfers can do, particularly if the new one you buy is an exact fit, in every single way, with the old one you remove. In that situation, it's important that you start any project by taking careful measurements in the old one, check out the water connection, electrical connection and every other dimension also. Let's take a look at what you need to caused by get this job done. - water heater installation
Taking Measurements Is very important
Get a tape measure and acquire the height, width, quantity of watts and gallon capacity with the water heater you have now. Naturally, pipes can be extended longer, in case your new appliance is shorter, so can the electrical connections if you need to, but most of the time you may get an almost exact match with the local building supply store, this will make your water heater installation much simpler. Make sure you turn off the ability at the fuse box, then turn off the water supply prior to getting started.
There Is A Drain Valve Towards the bottom Of The Tank
Hopefully you do have a sewer drain with your basement or utility room the place that the water heater is located or you may have to use a bucket making some trips backwards and forwards to empty the water from the old heater. A hose will fit the drain about the heater, if you're above walk-out you can drain the river outside. Carefully disconnect the wires and clean water connections, then haul that old appliance out. There are instructions online regarding how to make a BBQ grill out of your old metal tank with a search.
Bring The modern Water Heater In And Examine Any Differences In Connections
Check out the connections, water inlet, water outlet, positive electric, negative electric and possibly a ground wire. Make positive that they're not exactly the same you have the right conversion adapters for the task. Most electric water heaters may have the same 3/4 inch water pipes that is to be exactly the same as the old ones. Many times it's wise to buy new flexible pipes to prevent leaks caused by corrosion on the old ones.
After You've Connected The Water, And Electric Verify Everything
It's very important to verify both the electrical and water connections before you begin to fill the tank. Don't ever turn on the electricity before the tank is filled with water, this could ruin sun and rain inside immediately. Your hot water heater installation is nearly complete, turn water inlet valve on full, then switch on a hot water faucet in the home and run it until all the air has been eliminated from your system, and then some more to make sure. Double check everything again, then turn on the circuit breaker for you power to the new heater.
Replacing a classic water heater is a fairly simple job, but it is something that needs to be done properly to avoid problems. Just be sure you check and verify everything several times on the way and you'll do just fine. - water heater installation